Henny-penny OFE/OFG-322 Manuel d'utilisateur télécharger pdf (Page 19)

Model OFE/OFG-321,322,323,324

2-18. HEATING ELEMENTS

(ELECTRIC ONLY)

(Continued)

3. Perform an ohm check on one element at a time, with wires

disconnected from element. If the resistance is not within

tolerance, replace the element.

Voltage Wattage Resistance Ohms (cold)

208 4800 9

230 4800 11

Replacement:

Refer to figure 2-2.

1. Drain the shortening from the frypot.

2. Remove the high limit bulb holder from the heating element

inside the frypot.

3. Remove the heating element wires from the terminals by

removing the nuts and washers. Label each so it can be

replaced on the new element in the same position.

4. Remove the bolts from the five element spreaders. The

element spreaders will now pull off the elements.

5. Remove the brass nuts and washers which secure the ends of

the elements through the frypot wall.

6. Remove the heating elements from the frypot as a group by

lifting the far end and sliding them up and out toward the

rear of the frypot.

Always install new rubber O-rings when installing heater

elements.

7. Install new heating elements with the new O-rings, terminal

end first at approximately a 45° angle, slipping the terminals

through the front wall of the frypot.

8. Replace the brass nuts and washers on the element terminals.

Tighten the brass nuts to 30 foot lbs. of torque.

203 2-19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 28 29

Pas de commentaire

Henny-penny OFE/OFG-322 Manuel d'utilisateur Page 19