Henny-penny OFE/OFG-322 Manuel d'utilisateur télécharger pdf (Page 27)

Model OFE/OFG-321,322,323,324

2-22. AUTOLIFT

ACTUATOR (MOTOR)

REPLACEMENT

(if applicable) (Continued)

9. Remove the 2 front mounting screws from the actuator support

plate.

10. Remove all the top screws, securing all the actuator support

plates to the back shroud, to help loosen the back shroud.

11. Remove all remaining back shroud screws to loosen the back

shroud from the unit.

12. Lift up on the entire back shroud assembly, enough to have the

top of the actuator and bracket assembly to clear the top of

the back shroud. Pull the top of the actuator and bracket

assembly away from back shroud, as shown in Figure 10.

Now, using a flat-blade screwdriver, push the clevis pin from

the bracket and actuator and using pliers to pull the pin

from the assembly. Actuator can now be removed from unit.

13. Reassemble in reverse order.

606 2-27

1 2 ... 22 23 24 25 26 27 28 29

Pas de commentaire

Henny-penny OFE/OFG-322 Manuel d'utilisateur Page 27