Henny-penny OFG-391 Manuel d'utilisateur télécharger pdf (Page 16)

Model OFG- 391

1-4. ERROR CODES In the event of a control system failure, the digital display will show

an error message which are coded: “E-4”, “E-5”, “E-6”, “E-10”,

“E-15”, “E-20A-D”, “E-41”, “E-46”, “E-47”, “E-48”, “E-70B”,

and “E-92”. A constant tone is heard when an error code is

displayed; and to silence this tone, press any of the product buttons.

DISPLAY CAUSE PANEL BOARD CORRECTION

“E-4” Control board Turn switch to OFF position, then turn switch back to ON;

overheating if display still shows “E-4”, the board is getting too hot; check

for signs of overheating behind the control panel; once panel

cools down, the controls should return to normal; if “E-4”

persists, replace the control

“E-5” Shortening Turn switch to OFF position, then back to ON; if display

overheating shows “E-5”, the heating circuits and temperature probe should

be checked; once the unit cools down, the controls should

return to normal; if “E-5” persists, replace the control

“E-6A” Temperature Turn switch to OFF position, then turn switch back to ON;

probe open if display shows “E-6”, have the temperature probe checked

“E-6B” Temperature Turn switch to OFF position, then turn switch back to ON;

probe shorted if display shows “E-6”, have the temperature probe checked

“E-10” High limit Reset the high limit by manually pushing up on the red reset

button; if the high limit does not reset, the high limit must be

replaced; call Henny Penny’s Service Department

“E-15” Drain switch Close the drain using the drain valve handle; if display still

shows “E-15”, call Henny Penny’s Service Department

“E-20A” Air pressure switch Press the timer button to try the ignition process again; and if

failure (stuck closed) “E-20A” persists, call Henny Penny’s Service Department

“E-20B” Draft fan or Press the Timer button to try the ignition process again; and if

air pressure “E-20B” persists, call Henny Penny’s Service Department

switch failure

(stuck open)

“E-20C” Ignition module Press the Timer button to try the ignition process again; and if

failure “E-20C” persists, call Henny Penny’s Service Department

“E-20D” Modules working Press the Timer button to try the ignition process again; and if

but no ignition “E-20D” persists, call Henny Penny’s Service Department

1-10 305

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 78 79

Pas de commentaire

Henny-penny OFG-391 Manuel d'utilisateur Page 16