Henny Penny CW-114 Manuel d'utilisateur télécharger pdf (Page 9)

Model CW-216/CW-114

2-3. LOCATION Place the unit on a table, preferably with a cut-out opening below

the cabinet to allow easy service connections and serviceability.

When setting up the Henny Penny Display Counter Warmer,

be sure to level the table.

The unit has built-in draining capabilities, but this becomes

ineffective when set on an unlevel table.

After the Henny Penny Display Counter Warmer has been

leveled on the table, run a bead of silicone rubber (or equivalent

sealant) around the perimeter of the unit, sealing it to the table

top. You are now ready to make the electrical and drain

connections to the unit.

2-4. REMOVE CONTROL END 1. Remove the seven screws fastening the end panel to the

PANEL cabinet.

2. Slide bottom of end panel out first allowing top to drop

below shelf edge.

203 2-3

Step 2

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Pas de commentaire

Henny Penny CW-114 Manuel d'utilisateur Page 9