Henny Penny CW-114 Manuel d'utilisateur télécharger pdf (Page 18)

Model CW-216/CW-114

Fig. Item

No. No. Description Function

3-9 18 Power Light Illuminates when the power switch is on and the heat and

water system controls are energized; if the power light goes off

during normal operation, this means the water pan hi-limit device

has opened indicating that the unit is out of water

3-9 19 Radiant Heat The infinite regulator is a time proportioning controller; the higher

Infinite Regulator the number set means the radiant heat will be on a greater

percentage of time

3-9 20 Light Switch The light switch is a two-position, two pole switch used to turn the

lights on and off

3-9 21 Light Fuse Holder The fuse holder is a protective device for the lighting circuit; the

fuse is a 15 amp rating and must be replaced by a fuse of the same

size and rating

3-10 22 Float Switch An electro-mechanical sensing device used to automatically control

the water level in the water pan; the sensor can be inactivated by

the water control switch; the sensor illuminates the low water light

when it senses a low water condition

3-11 23 Water Heater The water heater is a flat strip heater which measures approximately

3” wide by 25” long; there are two heaters rated at 1020 watts

each attached to the bottom of the water pan

1107 3-5

3-2. OPERATING CONTROLS (Continued)

3-3. START-UP

Before using, the Henny Penny Display Counter Warmer should

be thoroughly cleaned as indicated in the Shut-down and

Clean-up section of this manual.

1. Move all switches and controls on the cabinet to the OFF

position.

2. Turn on power supply for the cabinet at the main circuit

breaker.

Step 2

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Henny Penny CW-114 Manuel d'utilisateur Page 18