Henny Penny CW-114 Manuel d'utilisateur télécharger pdf (Page 12)

Model CW-216/CW-114

2-8. WATER SUPPLY

CONNECTION

(Continued)

This unit as manufactured requires the installation of an appro-

priate back-siphoning device (as per National Plumbing Code

ASA-A40:8-1955) to be connected to the water inlet line.

This device to be connected in accordance with basic plumbing

code of the Building Officials and Code Administrators Interna

tional, Inc. (BOCA), and the Food Service Sanitation Manual

of the Food and Drug Administration (FDA).

Install a water shut-off valve in a convenient location.

2-9. LIGHT BULBS AND 1. Cut the tape holding the doors shut and remove all boxes and

GLASS PANELS boxes and packing. One carton contains the glass panels and

the other contains the light bulbs.

2. Install the light bulbs and glass panels.

3. The unit is now ready to be cleaned per instructions in the

Operations Section of this manual.

Replacing Light Bulbs

Step 2

Light bulbs and glass may be hot. Severe burns could

result.

1. Remove the glass panel by carefully pushing up on back of

panel and sliding away from you. The panel will fall into

your hand. See photo at left.

2. Remove the light bulb.

3. Replace the light bulb with a Westinghouse #60A19/35,

130 Volt bulb.

Step 1 If this bulb is not available, a standard 60 watt bulb will work

until a long life bulb can be obtained.

4. Replace the glass panel.

2-6 203

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Pas de commentaire

Henny Penny CW-114 Manuel d'utilisateur Page 12