Henny Penny PFE-590 Manuel d'utilisateur télécharger pdf (Page 45)

Model PFE- 590/592

4-2. ERROR CODES In the event of a control system failure, the digital display will

show an “Error Message”. These messages are coded: “E04”,

“E05”, “E06”, “E41”. A constant tone is heard when an error code

is displayed, and to silence this tone, press any of the product

buttons.

DISPLAY CAUSE PANEL BOARD CORRECTION

“E04” Control board overheating Turn switch to OFF position, then turn

switch back to ON; if display still shows

“E04”, the board is getting too hot; check for

signs of overheating behind the control

panel; once panel cools down the controls

should return to normal; if “E04” persists,

replace the control

“E05” Shortening overheating Turn switch to OFF position, then back to

ON; if display shows “E05”, the heating

circuits and temperature probe should be

checked; once the unit cools down, the

controls should return to normal; if “E05”

persists, replace the controls

“E06” Temperature probe failure Turn switch to OFF position, then back to

ON; if the display shows “E06”, the tempera-

ture probe should be checked; once the

temperature probe is repaired, or replaced, the

controls should return to normal; if “E06”

persists, replace the controls

“E41” Programming Failure Turn switch to OFF position, then back to

ON. If display shows “E41”, the control

should be re-initialized (see programming

section); if the error code persists, replace

the control panel.

“E71” Pump motor relay failure or Replace relay if contacts are stuck closed;

wiring problem check wiring on POWER/PUMP switch, or at

wall receptacle; L1 and N may be reversed

403 4-2

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 51 52

Pas de commentaire

Henny Penny PFE-590 Manuel d'utilisateur Page 45