Henny Penny PFE-590 Manuel d'utilisateur Page 34

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 52
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 33
Model PFE- 590/592
3-10. CLEANING THE FRYPOT
(Continued)
Do not use steel wool, other abrasive cleaners or clean-
ers/sanitizers containing chlorine, bromine, iodine or
ammonia chemicals, as these will deteriorate the stain-
less steel material and shorten the life of the unit.
Do not use a water jet (pressure sprayer) to clean the
unit, or component damage could result.
Make sure the inside of the frypot, the drain valve opening,
and all parts that come in contact with the new shortening are
as dry as possible.
3-11. FILTER PUMP MOTOR The filter pump motor is equipped with a manual reset button,
PROTECTOR-MANUAL located on the rear of the motor, in case the motor overheats. If
RESET motor won’t run, wait about 5 minutes before attempting to reset
this protective device to allow motor to cool. Remove the access
panel on the left side panel of the unit to reset the button. It takes
some effort to reset, and a screwdriver can be used to help reset
the button.
To prevent burns caused by splashing shortening, turn
the unit’s main power switch to the OFF position before
resetting the filter pump motors manual reset
protection device.
3-12. REGULAR As in all food service equipment, the Henny Penny pressure fryer
MAINTENANCE does require care and proper maintenance. The table below
SCHEDULE provides a summary of scheduled maintenance. The following
paragraphs provide preventive maintenance procedures to be
performed by the operator.
Procedure Frequency
Filtering of shortening See KFC’s Standards Library
Changing of shortening See KFC’s Standards Library
Changing the filter envelope See KFC’s Standards Library
Cleaning the deadweight assy. Daily-see Preventive
Maintenance Section
Cleaning the frypot See KFC’s Standards Library
Cleaning the Nylatrons Monthly-see Preventive
Maintenance Section
Reversing lid gasket Every 90 Days-see Preventive
Maintenance Section
Lubricate rear lid rollers Annually-see Preventive
Maintenance Section
Cleaning safety relief valve Annually-see Preventive
Maintenance Section
3-15 810
Vue de la page 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 51 52

Commentaires sur ces manuels

Pas de commentaire