Henny Penny G L O S S A R Y OFE- 290 Manuel d'utilisateur

Model OFE- 2903-1. OPERATING COMPONENTSPOWER/PUMP Switch A three way switch with center OFF position; move the switch tothe po

Model OFE- 2903-8. FILTERING 5. Scrape cracklings and crackling ring from frypot and discard. INSTRUCTIONS Do not let crac

Model OFE- 2903-10. CLEANING THE FRYPOT After the initial installation of the fryer, as well as before everychange of shorte

Model OFE- 2903-11. FILTER PUMP MOTOR The filter pump motor is equipped with a manual reset button, PROTECTOR-MANUAL l

Model OFE- 2903-14. PROGRAMMING 1. Press and hold the FUNCTION button for two seconds.“REG PROGRAM” shows in the display, foll

Model OFE- 2907. After the load compensation, press and release the FUNC-TION button. “PROP” and “CONTROL” shows on theleft sid

Model OFE- 2903-14. PROGRAMMING (continued)13. After the end-of-cycle point is set, press and release theFUNCTION but

Model OFE- 2903-15. SPECIAL PROGRAM MODE (Continued) Factory Presets (F/C, Gas/Electric, Speaker Volume,Speaker Frequ

Model OFE- 2903-15. SPECIAL PROGRAM MODE (Continued) Tech I/O Mode1. Press and hold the FUNCTION button for two secon

Model OFE- 2903-16. SPECIAL PROGRAM Heat Control MODE (Continued) 1. Press and hold the FUNCTION button for two s

Model OFE- 2903-1. OPERATING COMPONENTS (Continued)High Limit This high temperature control senses the temperature of t

Model OFE- 2903-4. SWITCHES AND Refer to image at end of this section. INDICATORSProduct Selection Buttons Select the n

Model OFE- 290EXIT COOL Button After cooking, or filtering the shortening, the temperature automati-cally goes into the Cool Mo

Model OFE- 2903-5. FILLING OR ADDINGSHORTENINGThe shortening level must always be above the heatingelements when the fryer is

Model OFE- 2903-6. BASIC OPERATION Follow the procedure below on the initial start-up of the fryer, andeach time the fryer is

Model OFE- 2903-6. BASIC OPERATION 4. Allow fryer to heat until digital display shows “DROP”. (Continued) (Press the

Model OFE- 2903-7. CARE OF THE SHORTENINGFOLLOW THE INSTRUCTIONS BELOW TO AVOIDSHORTENING OVERFLOWING THE FRYPOT,WHICH

Model OFE- 2903-8. FILTERING INSTRUCTIONS (continued)ONLY FILTER WHEN “COOL” IS DISPLAYED.FAILURE TO DO SO CAN