Henny Penny OE/OG 301/302/303 Manuel d'utilisateur télécharger pdf

This section provides troubleshooting information in the form of

an easy-to-read table.

If a problem occurs during the first operation of a new fryer,

recheck the installation per Section 2 of this manual.

Before troubleshooting, always recheck the operating procedure

per Section 3 of this manual.

LES

In the event of a control system failure, the digital display will

show an “Error Message.” These messages are coded: E5, E4, E6,

ElO, E15, E41, E50, E51, and E53.

en turn

switc

display shows E4, the control board is getting too hot. Check the

louvers on each side of the unit for obstuctions. If E4 persists,

Turn switch to OFF position, then turn switch back to ON. If

display shows E6, thermal sensor must be replaced. Refer to

section 6-4.

button. If high limit does not reset, high limit must be replaced

per section 6-5, or 6-6.

El5

E41, E50,

E5 1, E53

Drain Switch Close drain, using the drain valve handle. If display still shows

Failure

E 15 check drain valve section 6- 13.

Programming Turn switch to OFF, then back to ON. If display shows any of

Failure the error codes, the control panel needs replaced.

1 2 3 4 5

Page 1

This section provides troubleshooting information in the form of an easy-to-read table. If a problem occurs during the first operation of a new fryer

Page 2

NG LE With switch in POWER position and switch light not illuminated, fryer is complete ly inoperative. With switch in power position, swit

Page 3

Shortening will not heat, but lights are on. A. Pilot will not light (gas model) B. Pilot will not stay lit. C. Burner will not light,

Page 4

5-2. T LES NG (Continued) _% Heating of Low or improper shortening too voltage (elec. slow model) Heating of shortening too slow (elec. mode

Page 5

odel Foaming or boil- ing over of shortening. Shortening will Drain valve not drain from clogged with frypot crumbs Filter motor rum but

Pas de commentaire

Henny Penny OE/OG 301/302/303 Manuel d'utilisateur