Henny-penny HB-121 Manuel d'utilisateur télécharger pdf

HB-121

SECTION 2. INSTALLATION AND OPERATION

2-1. INTRODUCTION This section provides the installation and operation instructions for

the Henny Penny Hand Breader/Sifter.

Installation of this unit should be performed by a qualified

service technician.

Do not puncture the skin of the Hand Breader/Sifter with

drills or screws as component damage or electrical shock

could result.

2-2. UNPACKING AND The Henny Penny Hand Breader/Sifter is shipped in a corrugated

ASSEMBLY carton with sufficient padding to withstand normal shipping

treatment.

Any shipping damages should be noted in the presence of the

delivery agent and signed prior to his or her department.

To remove the HB-121 from the carton follow these instructions:

1. Carefully cut banding straps.

2. Remove carton from unit.

3. Remove unit from wooden skid.

Take care when lifting unit to prevent personal injury.

The unit weighs approximately 140 lbs. (63.5 kg).

4. Remove all accessories from unit for assembly.

The hand breader/sifter unit is completely assembled and tested

at the factory. However, to make shipping easier, some parts

are separated from the unit. These parts should be assembled

and installed at this time as follows. Refer to exploded view in

rear of this manual.

5. Assemble gussets (brackets) to back splash using four 10-24

wing nuts found in plastic bag taped to the breading table.

203 2-1

1 2 3

HB-121SECTION 2. INSTALLATION AND OPERATION2-1. INTRODUCTION This section provides the installation and operation instructions forthe Henny P

Page 2

HB-1212-2. UNPACKING AND 6. Holding back splash horizontal with basket hanger hooksASSEMBLY (Continued) facing you, hook back splash lip into

HB-1212-5. PRINCIPLE OF OPERATION AND CONTROLSFor best performance, your HB-121 should be level. Levelingfeet have been installed to c

Pas de commentaire

Henny-penny HB-121 Manuel d'utilisateur