Henny Penny 580 Manuel d'utilisateur

This section provides procedures for the checkout and replace- ment of the various parts used within the fryer. Before replac- ing any parts

All fryers are equipped with a drain valve micro-switch that prevents heat from coming on when the drain valve is open. With the dra

Henny Penny Model 580 5-11. TEMPERATURE PRO

Henny Penny Model 580 5-12. COMPLETE CONTRO

Henny Penny Model 580 5-14. PREVENTIVE

Check the gasket for any tears or nicks. If the gasket is damaged it needs to be replaced. Be careful that the lid doesn’t fall down

6. Using a l/Z” wrench, tighten the nut (already threaded on the cable) against the weight securing the cable into the weight. ull .\ \

Henny Penny Model 5805-17. PRESSURE PAD The pre

Henny Penny Model 5805-18. LID ADJUSTMENT If ste

ith the carrier and racks installed on the lid, the lid should down, in contact with the pot rim, when the lid is lowered. The user will

rior to servicing the solenoid valve, it is necessary to remove the side panel on the right side of the unit. 1. Remove the “tru-arc”

This high temperature control is a manual reset control which senses the temperature of the shortening. If the shortening temperature exce

Henny Penny Model 580 5-20. SOLENOID VALV

Henny Penny Model 580 5-21. OPERATING CON

Henny Penny Model 580 5-22. REMOVAL &

The drain valve is found underneath the cookpot in the back of the fryer. It is opened by pulling the red knob in the front of the fr

The nylatron strips fiil the gap in the shroud behind the lid. 1. Secure the lid with the lid stop bracket. emove one of the tru-ar

8. Lift the front shroud up and out, over the arms of the lid. 9. Thread the new nylatron strip through the track in the front shroud.

2

Remove electrical power supplied to the fryer by unplugging the unit, or by turning off the wall circuit breaker or electrical shock

Be sure capillary bulb of high limit is positioned as not to interfere with carrier or when cleaning the cookpot wall, or damage to capi

The Power/Pump Switch is a three way rocker switch with a center “OFF“ position. With the switch in the POWER position the fryer wii

Primary Heat The electric fryer requires two switching contactors: a primary contactor and a heat contactor. The primary contactor energizes

The following checks, are performed with the wall circuit breaker on, and the Power/Pump Switch in the ower” position. Extreme caution s

Each electric fryer uses two heating elements. Heating elements are available for 208 or 220/240,380 and 415 voltage. Check the data plate on

1. Drain the shortening. 2. Remove the high limit bulb holder from the heating element. 3. Remove the Control Panel. 4. Disconnect th