Henny Penny 6 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Cuisiniers Henny Penny 6. Henny Penny 6 User's Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 9
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
59
Installation
Refer to the following pages for important information regarding the
installation of LCS and LCG ClimaPlus Combis. It is recommended
that installation be accomplished by a certified and properly trained
technician.
NOTE: When installing a ClimaPlus combi, humidity calibration must
be performed. This process takes approximately 45-60 minutes. (page 62)
Site, leveling
1) Check for any transport damages. Should there be any signs of transport
damage immediately inform your dealer/freight forwarder.
2) Check installation site. Check entrance clearance.
Minimum entrance space needed without pallet:
Model 6 & 10: 35
1
2 in. (902 mm)
Model 1020: 49
5
8 in. (1262 mm)
Model 20: 39
7
8 in. (1012 mm)
Model 40: 52
1
2 in. (1332 mm)
Floor at installation site must be level.
Cold water line in place. (page 63)
2 in. (50 mm) drain connection installed.
Max. drain height for floor units: 4 in. (100mm)
Electrical power supply/protective measures installed and sized correctly.
(page 60-61)
3) Remove all cartons, packing materials, documents etc. from the interior cabinet.
4) Remove grid shelves/trolley from cabinet.
5) Take unit off the pallet.
Moving unit without pallet: Sizes 6, 10, 1020 (Fig. 1)
Moving unit without pallet: Sizes 20, 40 (Fig. 2)
Minimum clearance sides and back:
2 in. (50 mm)
Service clearance, left side:
20 in. (500 mm)
Clearance for door opening:
Model 6 & 10: 20
1
2
in. (521 mm)
Model 1020: 29
1
2
in. (749 mm)
Model 20: 28
3
4 in.(730 mm)
Model 40: 30
3
4
in. (781 mm)
Fig. 1
Fig. 2
Vue de la page 0
1 2 3 4 5 6 7 8 9

Résumé du contenu

Page 1 - Installation

59InstallationRefer to the following pages for important information regarding theinstallation of LCS and LCG ClimaPlus Combis. It is recommended that

Page 2 - Electrical

60Unit weights:LCS 6: 270 lbs. (123 kg) LCG 6 335 lbs. (152 kg)LCS 10 334 lbs. (152kg) LCG 10 384 lbs. (174 kg)LCS 1020 484 lbs. (220 kg) LCG 1020 584

Page 3 - INSTALLATION

61Choose conductor size according above tables and your local regulations.IMPORTANTGas units are voltage specific. Supply voltage must match voltage r

Page 4 - Humidity calibration

Once conversion has been completed, a “total reset” of the CPU-PCB must be done.Record all end-user (custom) programs before undertaking a Total Res

Page 5 - Water supply

63Fig. 12Fig. 13CBAFig. 14WAWAWZINSTALLATIONWater supply9) Drain Connection (WA) For drain connection (Fig. 12) use only steam temperature resistant

Page 6 - Gas supply

64General11) Technical DataWorking place specific noise level: <70dBAverage water consumption during operation:Model 6: 3.17 gal/hr (0.2 l/min.)Mod

Page 7 - Gas Leak Test

DO NOT attempt to use any type of gas other than that specified on the dataplate. Incorrect gas supply could result in fire or explosion resulting in

Page 8 - Gas Hook-up

66During pressure testing note the following:1. The unit and its individual shut-off valves must be disconnected from the gas supply piping system dur

Page 9 - Dry wall construction

67Utilize elbows when necessary to avoid sharp kinks or excessive bending. For ease of movement, install with a “lazy” loop. Gas appliance must be dis

Commentaires sur ces manuels

Pas de commentaire